Quote Originally Posted by davidstcldfl
Jackalope, I don't know how rigid the sides are...(?)
I was thinking ....How about taking some PVC, maybe 1/2 inch, form a 'circle' out of it, to what ever diameter would fit 'snugly' inside the top edge of the pool. That size pvc bends pretty easy...doesn't cost a lot. A coupling or two and some pipe.....It 'mght' keep the sides up.
Not sure how you could hold it in place...? Maybe drill a few small holes near the top edge and use wire or tie wraps....?
Actually, the top isn't as bad as the bottom ..... as the bottom sidewall curls under/expands, the top gets lower, causing the top of the water to get closer to the top edge of the pool sidewall. I'm thinking that if I can put something around the outside to pull the bottom back in to where it's supposed to be, that it might make the grade for a year or so